The DJI A2 Flight Controller is the most advanced multirotor stabilization controller on the market, and it ensures total ease of flight, reliability, and stability in any situation. The A2 is a total solution for aerial photography.
It’s a UAS that’s targeted at commercial and industrial multi-rotor platforms with simple configuration, easy installation and stable performance. It also supports customized motor mixing, which can meet the demand of high-end users.
Usually, the forward direction of a flying multi-rotor is the same as the nose direction. By using Intelligent Orientation Control (IOC), it's possible to lock the forward direction independent of the nose direction. It's also possible to lock the forward direction to a preselected home point.
A2 has a POI function: Point of Interest. When the GPS signal is good, users can record the current position of the aircraft as a point of interest by a preset switch on the remote controller. The aircraft can achieve a circling flight around the point of interest with the nose pointing at the POI in an area of 5 meters to 500 meters radius, when the roll command is given. This function is easy to set and simple to operate, it is suitable for all-round shooting of a fixed scenic spot.
Once you have enabled the Intelligent Landing Gear function in the assistant software, the landing gear defaults to the Lower position when the aircraft is on the ground; and the system will lower the landing gear in emergency, motor failure or auto landing in order to protect the aircraft and gimbal. You can choose to lower or retract the landing gear by a switch when the aircraft altitude is over 5m from the ground.
If the multirotor and its controller disconnects during flight, the system’s failsafe protection will come to the rescue and if the signal is good enough, the multirotor will return to home and land automatically.
You can also program a One Key Go Home function through the Assistant software.
This function means that when the aircraft is in attitude or GPS attitude mode, and one of the motors stops, the aircraft will retain good attitude and rotate around the frame arm with the stopped motor. In this condition, the aircraft is still under control and returns home safely and highly reduces the risk of a crash.
Size and Weight | ![]() |
---|---|
Peripheral | Supported Multi-RotorQuad-Rotor: +4,x4; Hex-Rotor +6,x6,Y6,Rev Y6; Octo-Rotor +8,x8,V8 Supported ESC Output400Hz refresh frequency Supported Transmitter For Built-In ReceiverFutaba FASST Series and DJI DESST Series External Receiver SupportedFutaba S-Bus, S-Bus2, DSM2 Recommended Battery2S ~ 6S LiPo Operating Temperature-5°C to +60°C Assistant Software System RequirementWindows XP SP3 / 7 /8 (32 or 64 bit) Other DJI Products SupportedZ15,H3-2D,iOSD,2.4G Data Link,S800 EVO |
Flight Performance | Hovering Accuracy(In GPS Mode)Vertical: ± 0.5m Horizontal: ± 1.5m Maximum Wind Resistance< 8m/s (17.9mph/28.8km/h) Max Yaw Angular Velocity150 deg/s Max Tilt Angle35° Ascent/Descent±6m/s |
Electrical & Mechanical | Power ConsumptionMAX 5W (Typical Value: 0.3A@12.5V) Built-In FunctionsBuilt-in Receiver Multiple Control Modes 2-axis Gimbal Supported Low Voltage Protection PC & Bluetooth Ground Station External Receiver Supported Intelligent Orientation Control Sound Alarm 4 Configurable Output Total WeightTotal Weight: <= 224g(overall) DimensionsFlight Controller: 54mm x 39mm x 14.9mm IMU: 41.3mm x 30.5mm x 26.3mm GPS-Compass Pro: 62mm (diameter) x 14.3mm LED-BTU-I: 30mm x 30mm x 7.9mm PMU: 39.5mm x 27.6mm x 9.8mm |