Insta360 ONE R DIVE CASE 4K

Features

197' Depth Rating

Two Control Buttons on Top

2-Prong Mount

The Dive Case for ONE R 4K Edition from Insta360 features a 197' depth rating, allowing for deep water diving. It supports the ONE R 4K Edition, which consists of the Core module, 4K Mod, and Battery Base. On top, it features two camera control buttons, and on the bottom, it provides a 2-prong mount for compatibility with 3-prong support accessories, such as a floating hand grip, sold separately.

IPX8 water resistant, protecting your ONE R for deep-water diving

Dive Case for Wide Angle Mod: Waterproof up to 196ft (60m)

*NOTE: The following instructions use the Dive Case for I-Inch Wide Angle Mode as an example.

1 Open the Case

Hold the Dive Case with the arrow pointing to your left, as shown. Push the lock lever to the left ( 1 ), then pull down from the second arrow ( 2 ). Remove it from the hook ( 3 ). When the buckle is completely disengaged, open the Dive Case.

2 Insert the Camera

Be sure to insert the camera in the correct direction.

Note:

1)When using the Dive Case for Leica edition, remove its protective lens first.

2)When using the camera in water, please lock the touch lock screen to avoid accidental presses.

3)When inserting the camera, take care not to scratch the lens.

Camera inserted!

3 Attach the Anti-Fog Inserts

Ensure that anti-fog inserts are inserted as shown left.

Note:

When using third-party anti-fog inserts, ensure that the size is within 25*16*1 mm. If the anti-fog inserts are too large, they will cause water leakage, damaging the camera.

4 Close the Case

To close the Dive Case, latch the buckle with the hook and push the buckle until it clicks.

Note:

1)Ensure the Dive Case is firmly closed. Be sure that the parts of the Dive Case in contact with its rubber seal are free of dirt or dust.

2)For the best results, keep the lenses of the Dive Case clean.

5 Attach the Stability Pads

When connecting the Dive Case to other accessories, such as the floating hand grip, be sure to stick a stability pad to the screw points.